連續拉桿 的英文怎麼說

中文拼音 [liánxùlāgǎn]
連續拉桿 英文
continuous draw bar
  • 連 : Ⅰ動詞1 （連接） link; join; connect 2 （連累） involve （in trouble）; implicate 3 [方言] （縫） ...
  • 續 : Ⅰ形容詞（連接不斷） continuous; successive Ⅱ動詞1 （接在原有的后頭） continue; extend; join 2 （...
  • 拉 : 拉構詞成分。
  • 桿 : 桿名詞（桿子） pole; staff
  • 連續 : continuation; succession; series; continuity; continuing; running; continuous; successive; contin...
  • 拉桿 : bar; straining beam; drawbar; dog iron; stake pole; queen bolt; tie rod; pull rod; drag link; ten...
  1. The development of basic functional models for computing, designing, editing and intercommunicating, such as the layout algorithm, the design and placement of dead block, and adding and deleting of heat tubes

    完成了系統必要的設計、編輯和交互功能，包括：折流板的設計與放置，連續增添及刪除換熱管、拉桿等。
  2. This paper presents the structural design of the main bridge of lhasa river bridge, makes a deep - going study of the key techniques for design of the bridge, such as the reasonable span length ratio of each span of the 5 - span girder and arch hybrid structure, mechanical behaviour of the dual arch ribs, and section of the continuous girder tie beam, and also works out rigidity and stress conditions of the continuous girder tie beam and stress conditions of the concrete - filled steel tube arches of the main bridge

    摘要介紹了拉薩河特大橋主橋結構設計情況，對於五跨梁拱組合橋梁各孔跨合理的跨度比、疊拱的受力行為及連續梁系桿截面形式等設計中的關鍵性問題進行了深入的研究，給出了主橋連續梁系桿的剛度和應力情況、鋼管混凝土拱的應力情況。
  3. Senna started from pole position at imola on eight occasions, including seven in succession from 1985 to 1991

    而塞納這創造了在伊莫拉賽道8次桿位的紀錄，包括了從1985到1991年連續的7次。
  4. Three factors, such as pull - up type, the materials and structure of crystallizing mould, and the temperature field in crystallizing mould, influencing on continuous up - casting for aluminum were analyzed, which laid the foundation of the application to continuous up - casting technology for aluminum bar

    分析研究了引拔拉坯制式、結晶模材料及結構、結晶模內溫度場三因素對鋁上引連鑄的影響規律，結果表明上引連續鑄造過程中施加適當頻率的反推和反推量有利於桿坯連鑄的持續，結晶模自身的性能及模內溫度場的狀態對金屬鋁桿上引連鑄工藝的實現有直接影響。
  5. Preparation and properties of heat - resistance carbon fiber pultruded composites for continuous sucker rods

    耐溫型碳纖維拉擠復合材料連續抽油桿的制備和性能研究
  6. Lu, w. y., lin, i. j., hwang, s. j., and lin, y. h., ( 2003 ) “ shear strength of high - strength concrete dapped - end beams, ” journal of the chinese institute of engineers, vol. 26, no. 5, pp. 671 - 680

    李宏仁、黃世建， （ 2002 ）鋼筋混凝土結構不連續區域之剪力強度評估-軟化壓拉桿模型簡演算法之實例應用，結構工程，第十七卷，第四期，第53 - 70頁。
分享友人
分享到 Line

分享到臉書