speed under load 中文意思是什麼
speed under load
解釋
負載轉速-
Then following reality constituent of engine and connecting component interface, a nonlinear signal cylinder engine model has been created, though fire interval and fire order, a control - oriented four cylinders engine is build. following dynamometer is seen as load, performance of engine is simulated and researched under the condition of constant torque and speed, validation of the math and simulation model have been confirmed by comparison result between simulation with test result of engine performance simulation software dyno
按照發動機的實際組成，根據各部件的介面類型連接模型庫中的部件，建立了單缸發動機非線性模型，在此基礎上，依據發動機實際發火間隔和順序，建立了面向控制的四缸汽油機模型，並以測功器為負載，通過恆轉矩和恆轉速方式進行了發動機性能模擬和研究，模擬結果和發動機動力性能模擬軟體dyno測試結果的對比驗證了數學模型和模擬模型的正確性。 -
It shows that the injection quantity and the difference of temperature distribute as a parabola which is at the same load, and the minimum of the parabola corresponds to the optimum quantity of injection ( g ). under the condition that the quantity of injected mass, the air speed and the heat quantity is respectively g, v and q, the research demonstrates that the pentium iv chip ' s temperature variation can be controlled under 40c and work normally when the wind speed overpass 1. 5m / s and the power dissipation of the chip is 60w. otherwise this paper calculates the flooding limit of thermosiphon with several different methods
對其充灌量、散熱量、電子元件（ cpu模擬晶元）表面與環境溫度之差及通風、流速的影響進行了系統的測試，發現充液量與溫差的關系在負荷不變時呈拋物線分佈，其極小值點對應的充液量是最佳充液量g 。在充液量為g時，對風速v 、散熱量q進行的研究表明，當風速超過1 . 5m / s后，奔騰晶元在60w發熱條件下晶元溫度小於40 ，能滿足長期正常工作。 -
Abstract : in this study distributions of block compression force on the driving and driven pulleys were measured using a ting load - cell inserted between two blocks and a telementer system, under several constant speed ratios
文摘:本研究採用超小型測力儀插入兩推塊和遙測裝置之間在幾種固定速比下測量主動和從動帶輪上推塊壓縮力分佈。 -
The working principle of liquid helium cryocondensation pump is strong absorptive force between 4. 2k cryogenic surface and gas molecules. the pump has great advantage in large instant pumping speed under high gas load, large working pressure range, high & neat ultimate vacuum
利用4 . 2k低溫面對氣體的物理吸附機制實現高氣載下瞬時大抽速的液氦低溫冷凝泵，具有工作壓強范圍寬、能獲得清潔真空環境的特點。 -
The main function of a governor is to monitor the speed deviation of a hydro turbine unit and convert it into the displacement deviation of the servomotor according to a specific characterisic. it is used to control the opening of the guide apparatus and to ensure the unit run steadily at fixed speed under a given load
調速器的主要功用是檢測機組轉速偏差，並將它按一定特性轉換成接力器的行程偏差，藉以調整機組導水結構的開度，使機組在給定的負荷下以給定的轉速穩定運行。 -
The thesis had done the theories analysis in detail and built the relevant mathematics models aiming at the mechanics characteristic about the lodging of stalk, the elastic and plastic deform of stalk under the action of the transverse loads, the mechanics condition which causes stalk pushed, the relation between the speed of unit and the surface radius of ski, the relevant location between the thickness of the compressed stalk and action location of load, the relevant location between the mating device and plough, the coefficient of overturning soil under the thickness of the compressed stalk and so on. in addition, the computer aided analysis and simulating experiments in field were acted by choice
本文對秸稈自倒伏力學特性；橫向載荷作用下的莖稈彈塑性變形與秸稈被推倒的力學條件；機組作業速度與滑撬曲面半徑的關系；秸稈壓實厚度與加載作用點的相對位置；配套裝置與犁體相對位置；秸稈壓實厚度下的翻垡系數等，進行了較詳細的理論分析並建立了相關數學模型。在此基礎上，本項研究還選擇性地進行了計算機輔助分析和田間模擬試驗。 -
For the reason of center plate split, in the raising speed and heavy - load transportation, the vehicles temporary repair rate rise continually. under existing technical condition, this paper analyzed the reason of center plate split, and gave the corresponding measurements to improve the quality of the center plate repair by ameliorating the technological process
在鐵路提速、重載運輸中，有因車輛心盤裂損而造成車輛臨修率持續增加的現象，對心盤裂損故障的原因進行了分析，提出了在現有技術條件下，通過改進心盤檢修工藝來提高心盤檢修質量，以及管理上應採取的措施。 -
The wear - resistance of the rps tin coating is significantly higher than that of the quenched m2 high - speed steel. the wear resistance of the quenched m2 high - speed steel was improved about 2. 5 times by the rps tin coating under high load. the antifriction performance of the tin coating is also very excellent due to the self - lubricating effect of tin, the friction efficient of which is about 5. 3 % that of the quenched m2 steel
在無潤滑條件下，反應等離子噴塗tin塗層的耐磨性明顯高於淬火m2鋼，在高載荷下，其耐磨性是m2鋼的2 . 5倍；同時，由於tin的自潤滑效應，塗層的減摩性遠遠優于m2鋼，高載荷下摩擦系數僅是m2鋼的5 . 3 。 -
Through the loss model of lim, best efficiency control scheme is proposed based on the vector control, by which low efficiency of lim under light load or low speed is improved. the control scheme is proved effective through simulation under a specified speed - location curve
通過建立電機損耗模型，在矢量控制的基礎上設計了最優效率控制策略，解決了輕載或低速運行時的效率低下問題，通過指定速度位置曲線下的模擬分析驗證了控制策略的有效性。 -
Conclusions are drawn as follows : ( 1 ) regulating the electromotor speed by adjusting the input voltage is easy to carry out, and it can be used in most of the oil fields ; ( 2 ) good energy - saving effect can be achieved under the condition of light load on the motor ; ( 3 ) the voltage cannot be regulated in a large range, and the optimal range of the voltage regulation is less than 10 % of the rated voltage
由此得出結論： （ 1 ）調電動機端電壓調速方法簡單，一次性投資少，易於實現，對於一般的油田都適用； （ 2 ）調壓調速只有在輕負荷時，即在負荷遠未達到滿負荷時才有一定的節能效果，適用於油田普遍存在的「大馬拉小車」的情況； （ 3 ）電動機調壓調速的范圍不能太大，電壓調整的最佳范圍為額定電壓的10 %以內。 -
The results of the experiment show this creative ac variable frequency speed - governing experiment system can realize the load relationship of direct electromagnetic torque between the motor group, get the continuous control process easily for the reaction load and potential energy load during four quadrant, achieve the total availability of the regenerate energy at any kind of load, and the system consumed power make up under 30 % of actual load power at any kind of load
該方案研究獲得的實驗結果表明：這種具有創新特色的交流變頻調速實驗系統可實現電動機組之間直接電磁轉矩方式的負載關系，可方便地獲得電動機在反應或位能負載特性下四象限運行的連續控制過程，並實現了任意負載方式下再生能量的全部回饋利用，任意負載下系統消耗功率僅占電動機實際負載功率的30 %以下。 -
With the testing system, the mechanical load is applied and the relationship between the mechanical load and the revolution speed of the ultrasonic motor is studied under the vacuum condition
通過該裝置實現了對超聲電機負載力矩的施加以及在真空環境下對超聲電機轉速、轉矩的測量。 -
The study showed that under contain load and input speed, the output speed of the coupling could be controlled by modulating the strength of the applied dc field, which provides a new control means for continuous speed modulating of a transmission system
實驗表明，在確定負載和輸入速度下，可以通過調節直流電場控制聯軸器的輸出速度。這為傳動系統的無級調速提供了一種新的更簡便的手段。 -
And it can be controlled running at a rating slip, when its efficiency is the highest. then, simulation model of lim vector control system is constructed, which is proved accurate by simulation results under different speed and different load. and it is concluded that lim efficiency is lower under light load or low speed
其次，建立了考慮邊端效應的直線感應電機矢量控制系統的模擬模型，不同速度和負載下模擬結果驗證了模型的有效性，得到了電機在輕載或低速運行時效率較低的結論。 -
Purpose ： the equipment is used for mensurating refractoriness under load and creep speed
用途：該設備用於測定耐火材料荷重軟化溫度或蠕變率。 -
Under a constant applied load and sliding speed, the wear rate of cu - nanosized tib2 in - situ composites was increased with increasing the electric current. the predominant electric wear mechanisms of the cu - nanosized tib2 in - situ composites are abrasive wear and arc erosion
在一定載荷和滑動速度下，隨電流的增加， cu -納米tib2原位復合材料的磨損率增加， cu -納米tib2原位復合材料的電接觸滑動磨損機制主要為磨粒磨損和電侵蝕磨損。 -
Governor a governor is a device on the engine which controls fuel to maintain a constant engine speed under various load conditions
調速器調速器是安裝在發動機上的一個裝置，在不同的負載條件下通過控制燃料量來保持發動機的恆定轉速。 -
It is measured at a speed of 2m/s under load intensity of 1. 96mpa.
它是在載荷集度為196Mpa和速度為2ms時測得的。 -
It is measured at a speed of 2ms under load intensity of 1. 96mpa
它是在載荷集度為1 96mpa和速度為2m s時測得的。 -
It is measured at a speed of 2m / s under load intensity of 1. 96mpa
它是在載荷集度為1 96mpa和速度為2m s時測得的。
分享友人