相互獨立變數 的英文怎麼說

中文拼音 [xiānghùdúlìbiànshǔ]
相互獨立變數 英文
mutually independent variables
  • 相 : 相Ⅰ名詞1 （相貌; 外貌） looks; appearance 2 （坐、立等的姿態） bearing; posture 3 [物理學] （相位...
  • 互 : 代詞（相互;彼此） each other; mutual
  • 獨 : Ⅰ形容詞（一個） single; only; sole Ⅱ副詞1 （獨自） alone; by oneself; in solitude 2 （唯獨） only...
  • 立 : 動1 （站） stand; remain in an erect position 2 （使豎立; 使物件的上端向上） erect; stand; set up...
  • 數 : 數副詞（屢次） frequently; repeatedly
  • 相互 : mutual; reciprocal; each other
  • 獨立 : 1. （單獨站立） stand alone 2. （自主自立; 不受人支配） independence 3. （不依靠他人） independent; on one's own
  1. Mutually independent variables

    相互獨立變數
  2. Only when it takes humidity ratio h / ? as independent variable instead of absolute humidity h in researching and calculating the influence degree of the humidity on the discharge voltage, the emendation coefficients of relative air density and humidity can be independence, and can reflect the influence degree of atmospheric parameters on outer insulation discharge voltage actually

    當以比濕h代替絕對濕度h為自變量研究和計算濕度對放電電壓的影響程度時，相對空氣密度校正系數和濕度校正系數才能相互獨立，才能真實地反映大氣參數對電氣設備外絕緣放電電壓的影響程度。
  3. Based on the current jiangmen independent coordinate system and the method of coordinate transformation, this paper analyzes and resolves the coordinate transformation between jiangmen independent coordinate system and beijing geodetic coordinate system 1954 using 10 - parameters orthomorphic map projection transformation formula, then validates the results of coordinate transformation and analyzes the precision

    摘要以現有江門獨立坐標系及坐標轉換公式著手，分析了江門獨立坐標系與54北京坐標的相互轉換，提出了10參數正形變換方法，並進行了轉換計算結果驗證及精度分析。
  4. In this paper, we derive predictive models of system and auxiliary system from double constant alterations respectively. the controller based on d - step ahead predictor can locate the closed loop poles at desired positions, whose parameters are adjusted by estimations of plant parameters that are separately estimated. an auxiliary estimator is developed to avoid ill - condition in solving diophantine equation. simulations show that these control systems have better dynamic responses under existence of measurable disturbance

    引入雙恆等變換推導出系統及輔助系統的的d步預測模型，基於估計器的自校正控制器能將閉環極點配置在所希望的位置，它的參數是由與其相互獨立的對象參數調節.提出使用輔助估計器克服丟番方程的病態問題.模擬表明在存在可測干擾的情況下該系統具有良好的動態性能
  5. Abstract : in this paper, we derive predictive models of system and auxiliary system from double constant alterations respectively. the controller based on d - step ahead predictor can locate the closed loop poles at desired positions, whose parameters are adjusted by estimations of plant parameters that are separately estimated. an auxiliary estimator is developed to avoid ill - condition in solving diophantine equation. simulations show that these control systems have better dynamic responses under existence of measurable disturbance

    文摘:引入雙恆等變換推導出系統及輔助系統的的d步預測模型，基於估計器的自校正控制器能將閉環極點配置在所希望的位置，它的參數是由與其相互獨立的對象參數調節.提出使用輔助估計器克服丟番方程的病態問題.模擬表明在存在可測干擾的情況下該系統具有良好的動態性能
  6. The results of factor analysis showed that the following three shell factors are independent, and that there are no correlations among them : shell size, shell flatness and protoconch whorl number

    因子分析結果顯示殼大小、殼扁度及原殼螺層數三種殼因子是相互獨立的，它們之變異互不相關。
  7. Our results show that the rate of correlation among the random variables of those output sequences are low although they are not independent ; in addition, the output sequences of those combined generators are homogeneous markov chains which are strictly stationary processes with ergodicity ; the output sequences of those combined generators are also proved to summit to the strong law of large numbers and the central limit theorem ; finally the computation formula of the rate of the accordance between the output sequences and input sequences of those combined generators is given

    我們的研究結論表明：雖然這些序列中隨機變量之間不具有相互獨立性，但它們的相關程度卻比較低；證明了「停走」生成器， km _ 1m _ 2型組合生成器和加法型組合生成器的概率模型輸出序列都是強平穩的和遍歷的齊次馬氏鏈；討論了這些序列的概率極限性質，證明了它們均服從強大數定律和中心極限定理；還分別給出了各類生成器的輸出序列與輸入序列之間的符合率的計算公式。
  8. In the course of design, we fully consider the actual conditions on the railway and take a series of corresponding measures to the concrete problem. such as we select high - accuracy microconvertor and have the converted function in succession data collecting system chip aduc812, design v / f circuit and external a / d circuit. in anti - interference of the hardware, we try to disperse each function module to avoid interfering each other, adopt photoelectric isolated technology to dispel the circuit connection of input and output. in controlling we import arithmetic mean into strain wave algorithm and real computing technology of virtual value for sample treatment of data, that is using the software to smooth away interfere error and to calculate actual value, thus it makes the precision of the data improve greatly

    在設計過程中，根據系統要求，充分考慮鐵路上的實際情況，針對具體問題採取了一系列的相應措施，如在器件選擇方面選用高精度microconvertor系列、具有adcdma連續轉換功能的數據採集微控制器晶元aduc812 ，設計了v f變換電路和外部a d轉換電路；在硬體抗干擾方面，將每個功能模塊盡量分散獨立開來以避免相互干擾、採用光電隔離技術消除輸入輸出通道上的電路聯系；在控制方面對于采樣數據的處理引入了算術平均值濾波演算法和真有效值的計算方法，即通過使用軟體來濾除系統中有干擾造成的誤差並計算真值，從而使數據的準確性得到極大地提高。
  9. But in more situations the random variables generating counting processes may not independent identically distributed, and in all kinds of dependent relations, negative association ( na ) and positive association ( pa ) are commonly seen. the research and apply in this aspect are rather valuable. in chap 2 we prove wald inequalities and fundamental renewal theorems of renewal counting processes generated by na sequences and pa sequences ; in chap 3 we are enlightened by cheng and wang [ 8 ], extend some results in gut and steinebach [ 7 ], obtain the precise asymptotics for renewal counting processes and depict the convergence rate and limit value of renewal counting processes precisely ; at last, in the study of na sequences, su, zhao and wang ( 1996 ) [ 9 ], lin ( 1997 ) [ 10 ] have proved the weak convergence for partial sums of stong stationary na sequences. however product sums are the generalization of partial sums and also the special condition of more general u - statistic

    但在更多的場合中，構成計數過程的隨機變量未必相互獨立，而在各種相依關系中，負相協（ na ）和正相協（ pa ）是頗為常見的關系，這方面的研究和應用也是頗有價值的，本文的第二章證明了na列和pa列構成的更新計數過程的wald不等式和基本更新定理的一些初步結果；本文的第三章則是受到cheng和wang [ 8 ]的啟發，推廣了gut和steinebach [ 7 ] ）中的一些結論，從而得到了更新計數過程在一般吸引場下的精緻漸近性，對更新計數過程的收斂速度及極限狀態進行精緻的刻畫；最後，在有關na列的研究中，蘇淳，趙林成和王岳寶（ 1996 ） 》 [ 9 ] ，林正炎（ 1997 ） [ 10 ]已經證明了強平穩na列的部分和過程的弱收斂性，而乘積和是部分和的一般化，也是更一般的u統計量的特況，它與部分和有許多密切的聯系又有一些實質性的區別，因此，本文的第四章就將討論強平穩na列的乘積和過程的弱收斂性，因為計數過程也是一種部分和，也可以構成乘積和，這個結果為研究計數過程的弱收斂性作了一些準備。
  10. Control output has two kinds : each channel unite alarm transmit output ; each channel respectively independent alarm transmit output. unite alarm type again classified into : alarm memory and alarm no memory type

    顯示方式有兩種：雙屏數碼顯示雙屏數碼雙光柱顯示控制方式：兩路相互獨立的繼電器控制報警輸出或模擬量變送輸出。
  11. We also give the reliability analysis of cold -, warm standby repairable system of two components with continuous lifetime switch and priority, under the condition that the operating time and maintained time of the two components and the lifetime and repair - time of the switch are all exponential distributions. all the variables are independent, and the lifetime of operating components have nothing to do with its maintained time, and the failure components and switch can be as good as new after repair

    對于由兩個不同型部件組成的、有優先權的、開關壽命為連續型隨機變量的冷、溫貯備可修系統，本文在兩部件的工作時間、維修時間以及轉換開關的壽命和修理時間均服從指數分佈、所有隨機變量均相互獨立、工作部件的壽命分佈與其貯備時間無關、故障部件和轉換開關均可修復如新的情況下作了研究。
  12. Let be a sequence of independent and identically distributed random variables ， with mean and variance. while the distribution function is unknown ， and is large ， then is a normal approximation distribution

    3設相互獨立的隨機變量服從同一分佈，已知均值為，方差為.單分佈函數未知，當充分大時，近似服從正態分佈
  13. It consists concretely of data management, information indexing, statistics analysis, selecting measures and foreseeing forest resource, help system modules and etc. every modules can be run autonomously to improve the independence of the system in order to manage and assert the system

    系統可以實現數據管理、信息查詢、統計分析以及根據經營目標選擇經營措施等功能，並且可以預測未來的資源變化和消長情況。組成系統的各模塊之間相互獨立運行，增強了系統的獨立性，便於系統的管理和維護。
  14. The improvement on the process of automatically measuring city buildings is one of the most important problems in the current aerial photographic measurement. an approach to measuring a city building based on its structure information is presented. a city building ' s ideal model is first represented by some independent parameters according to its structure information and some image variants which can induce model parameters are defined, and then the initial value of image variants are acquired by combining all kinds of information in the left and right images. finally the optimal location of the building is found for some certain criteria. an implementation of this method is illustrated on flat - roof and rectangular buildings in detail. the experimental results show that not only the method is more automatic than existing methods but also the precision of measurement can satisfy the acquirement of the current aerial photographic measurement, and confirm the method has a good developmental and applied potential

    提高城市建築物測量過程的自動化程度是目前航空攝影測量研究的主要問題之一.文中提出了一種基於結構信息的城市建築物測量方法.首先根據城市建築物的結構信息，用幾個相互獨立的參數來描述建築物的理想模型，並定義能推導出模型參數的圖像變量，然後組合利用左右圖像中各種信息獲得圖像變量的初始值，最後在一定準則下尋求城市建築物的最佳測量位置.該文以平頂矩形建築物為例詳細討論了它的一種實現演算法.實驗結果表明，這種方法與傳統方法相比較，有較高的自動化程度，且測量精度能滿足現有航空攝影測量的要求，有較大的發展和應用潛力
  15. Therefore, if the soil water properties and soil water - storage was studied with traditional statistic method, we would not know the variate are dependent or independent, whether the results have spatial distributing pattern or not, even not know whether the number of sample is economical and rational or not

    因此用傳統方法分析土壤水分特性和水庫貯量並不清楚所得的數據是否相互獨立，是否存在一定的空間分佈格局，更不知道所確定的取樣數量是否經濟、合理。地統計學是研究土壤特性空間變異和空間分佈格局最有效的方法之一。
分享友人
分享到 Line

分享到臉書